How to Make Tomato Cages

0
1843

Commercial tomato cages are often too wimpy for Kansas conditions.  Fortunately, you can make your own cages from concrete reinforcing mesh (wire).  This material is normally 5′ high with the “mesh” forming 6″ squares.  The shortest rolls are usually 50′ long, but some lumber yards will cut off just the amount you need.  Figure 6.5 feet of mesh to complete one cage.  You will need to cut the mesh in order to make the cages.  Small bolt cutters work well for this.  Be careful when cutting as the mesh comes in rolls that will spring back into a cylinder as the last cut is made.

Count off 13 squares but cut each horizontal wire at the end of the 13th square.  This will leave a series of 12 complete squares horizontally with prongs left on the 13th square.  Use these prongs to make a cylinder by bending the prongs over the vertical wire on the first square.  Cages using this method will be about 2 feet in diameter.  Tomatoes with large, rangy vines need all five feet of the mesh, but those with shorter, semi-determinate vines can get by with a shorter cage.

Also, cut off the bottom horizontal wire to leave prongs that can be pushed into the ground to help with stability.  In windy locations, a T-post will likely need to be driven near the cage.  Tying the cage to the T-post can help prevent the cage from toppling in windy conditions.

These cages will last for years, but do take up a great deal of storage space when not in use. (Ward Upham)

LEAVE A REPLY

Please enter your comment!
Please enter your name here